AER-TRN-01-P01 / CONCEPT DRAFT 1.0

Access and supported withdrawal

Fictional inert trainer only; source/training reviewer approval required before training use. No operational aircraft, OEM, qualification, licence-credit or release authority.

Article AER-TRN-01 / lesson TRN-LRU-01. Human review is required.

StepActionExpected evidenceHold or limitation
1Confirm the training article

Read AER-TRN-01 and BAY-01; compare with the assigned lesson.

The article and source identify the same inert trainer.A different or unreadable article ID means HOLD.
2Freeze the lesson revision

Use TRN-LRU-01 v2 teaching-cue concept; retain A permitted and B excluded.

The revision and allowed-unit list are recorded.A missing source or changed list requires reviewer disposition.
3Confirm an inert training setup

The instructor establishes the permitted inert setup and supervised scope. This draft does not supply a real isolation procedure.

The reviewer has accepted the training conditions.Do not apply this draft to energized equipment or an aircraft.
4Review the support and access space

Identify AP-01, its left hinge and R1/R2 with the support bed.

The intended model access and rail path are understood.Missing support or an obstructed sweep means HOLD.
5Identify and release D1

On the reviewed model, operate the upper catch D1.

D1 is visibly clear.Do not infer a safe release from an occluded view.
6Identify and release D2

Operate lower catch D2 before AP-01.

Both catches are visibly clear.An engaged catch blocks the panel step.
7Open AP-01

Use the source left-hinge direction to reveal the bay.

Panel-open reference state matches the named model.Do not force another hinge direction or claim physical clearance from this viewer.
8Identify P1 and J1

Distinguish the moving bay plug from the unit-fixed receptacle.

One plug and one receptacle are identified.Ambiguous identity or source detail means HOLD.
9Review separation and harness parking

In a reviewed demonstration, separate the coupling and park the harness outside the rail path.

Coupling and parked-harness evidence are available.A cable across the path blocks rail travel.
10Review T1 and T2

Identify unit-mounted retainer cams and cabinet-fixed keepers.

The model/source shows the intended clear retainer state.Unclear pivot, keeper contact or state requires review.
11Inspect supported withdrawal

Use the withdrawn GLB to inspect rail alignment and continuous support.

Both rails and the support bed remain part of the plan.A static GLB is not proof that a physical movement was completed.
12Record the checkpoint

Record the named withdrawn state and any missing view before the configuration decision.

A reviewer can trace source, state and unresolved gaps.The existing tray-transfer checkpoint is not a demonstrated continuous lateral lift.